Loading ...KKE 501 : Automatic Drive through Truck Wash Equipment
Equipment Overview
This equipment is of stationary type where the vehicles drive through the system slowly as the equipment washes it. The equipment is automatic in operation and is controlled by PLC (Programmable Logic Controller).
Features
KKE 501 Truck Wash Equipment : Standard Equipment Features
Parts of Equipment :
| The structure is made of heavy rectangular and square tubular sections (as per IS 4923 ) which are painted with anti corrosive paint. The structure is stationary and the vehicles pass through it. |
The water system consists of 3 High pressure pumps. The nozzles which are made of stainless steel 304 are used to spray water on the vehicle. All the pipes on the equipment are made of Stainless Steel grade 304. |
| The control system is housed in an Powder Coated Box. The equipment is controlled by Programmable Logic Controller. The photo-sensors detect the presence of the vehicle and PLC starts the washing program accordingly. |
| The operator controls are mounted on the front of the control panel; which lets the user to operate the equipment . The equipment can work in two modes AUTOMATIC / MANUAL . In unattended mode, as soon as the system detects the vehicle the wash program starts immediately. The pumps switch ON automatically and when the vehicle leaves the wash bay, the pumps switch OFF automatically. In Manual mode , the operator can switch ON each pump , operate pneumatic cylinders individually. The manual mode is also very useful for fault diagnosing or routine checking of the equipment. |
| Wheel guides help to position the cars to be washed at correct place at the wash bay, hence ensuring safety of the equipment as well as the car. |
 |
Under Chasis wash takes place at the entry of the wash bay. The under chassis wash uses the same water pump, that for the main high pressure arch. It consists of network of special high impact nozzles, which remove dirt effectively from the bottom surface. The Under Chassis Wash System is controlled from the Operator’s Panel. It can set to two modes, they are :- Automatic and Manual. When the system is switched to Automatic Mode, the Under Chassis Wash system gets activated automatically as the vehicle enters and is deactivated as soon as the complete truck passes over it. The nozzles, fittings and pipes, all are made up of Stainless steel, which ensure prolonged service life. All the rotating parts use Solid State Teflon bearings, which can run in harshest environments and do not require any lubrication throughout their life. |
Optionals
An arch is installed at some distance from the wash bay. As the truck moves through it, the blowers start automatically and remain ON for 60 secs (depends on local conditions) or till the truck is moving through it. There are eight blowers , two on the top and three on each side.
Ordering Code : DS02 - 501
This spares kit consists of most of the items which get worn off and may be needed to be replaced for providing uninterrupted service to your customers. It is always good to have spares rather than ordering them when they are actually required. With the spares kit, you’ll will able to avoid the downtime as you may replace the parts immediately.
Ordering Code : SK01 - 501
Technicals
Washbay Dimensions
| Preferred | Minimum | |
| Length | 13 m |
|
| Width | 6 m |
|
| Height | 6 m |
Washable Dimensions
| Length | |
| Width | 2.75 m |
| Height | 4.0 m |
Electrical Power
Option : 3 Phase 440 V A.C. 50 Hz.
Option : 3 Phase 380 V A.C. 50 Hz.
Option : 3 Phase 208 V A.C. 60 Hz.
Gallery
Visitor Comments
Home Contact Us Dealership Login Sitemap
Car Wash Equipment Bus Wash Equipment Truck Wash Equipment
© K.K. Electronics , KKE Wash Systems 2000 - 2008
